Seismic Lokton Griptape Lasercut Hole Pieces 36-Grit
    • Seismic Lokton Griptape Lasercut Hole Pieces 36-Grit

    Seismic Lokton Griptape Lasercut Hole Pieces 36-Grit

    13,50 €
    Out of stock
    Incl. 21% VAT

    A pack chockfull of lasercut hole pieces of the 36-grit Lokton sheets from Seismic. Available in different hole-patterns that not only appeal to aesthetic, but reduce weight on top of your board while the edges of the pieces increase grip!

    Model
    • Fishnet
    • Honeycomb
    • Metal-Plate
    • Ninja
    Quantità
    Non ci sono abbastanza prodotti in magazzino

      Maglietta gratis > € 150,-

    Ricevi una maglietta per il malato gratis se ordini per più di 150 euro

      Parcheggio gratuito

    Disponiamo di un parcheggio proprio davanti alla porta

      Spedizione gratuita a partire da € 150,-

    Si ottiene la spedizione gratuita in Benelux e Germania quando si ordina per più di 100 euro , Resto d'Europa da 200,-

      Diritto di recesso di 100 giorni

    È possibile restituire il prodotto non utilizzato entro 100 giorni (vedi la nostra politica)

      Spedizioni in tutto il mondo

    Spedizione in tutto il mondo, gratuita per ordini superiori a 300 euro (Asia 600 euro).

    Color: Midnight Blue
    Size: Various sizes
    Type: Coarse
    Grit: 36

    These Lokton pieces are available in Honeycomb, Metal-Plate, Ninja and Fishnet pattern. The hole pieces decrease lots of weight since you can apply them wherever you want on your deck. This 36 grit is one of the grippiest tapes on the market and will perform in heat or rain. This pack contains approximately 50 lasercut hole pieces of 36-grit Lokton griptape.

    Make sure you apply this griptape on clean, dry deck surfaces at room temperature.
    For best results, follow these directions:

    1) If deck is coated with excess lacquer, buff with fine sandpaper and clean off residue with Naptha.
    2) Use a blow dryer or heat gun to warm up Lokton after removing release paper but before placing on deck.
    3) Place on deck, then immediately apply pressure by standing on all areas of the Lokton.
    4) Trim edges by cutting from the top. Do not bend or file edges, as this can cause excessive grain shedding.

    The PSA (pressure-sensitive adhesive) on the back of Lokton is some of the best, most heat-resistant on the market. However, it does not always bond well to unusual combinations of deck-top materials and finishes, especially certain types of Formica and heavy lacquer. The results may vary.

    0710664751483
    W-C-27-4-2

    Scheda tecnica

    {0}

    Domanda (0)

    Non ci sono domande dei clienti per il momento.


    La tua domanda è stata inviata con successo il nostro team. Grazie per la domanda!
    Fai una domanda
    nascondere la forma

    Commenti Tutte le recensioni

    Riepilogo

    0

    star_border star_border star_border star_border star_border

    (0 Recensioni)

    Seleziona un punteggio per filtrare le recensioni.

    editScrivi una recensione